Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

SEBU8726-03 109 Maintenance Section Fuel Tank Water and Sediment - Drain 2. Lubricate the O ring seal (6) with clean engine oil. Do NOT fill the filter bowl (2) with fuel before the filter assembly is installed. Open the drain valve on the bottom of the fuel tank in order to drain the water and the sediment. Close the drain valve. 3. Do not use a tool in order to install the filter assembly. Tighten the assembly by hand. Install the filter bowl (2) and align with your temporary Marks. Check the fuel daily. Allow five minutes after the fuel tank has been filled before draining water and sediment from the fuel tank. Fill the fuel tank after operating the engine in order to drive out moist air.

This will help prevent condensation. Do not fill the tank to the top. The fuel expands as the fuel gets warm. The tank may overflow. 4. Tighten the drain valve (3). Turn the fuel supply valve to the ON position. 5. The Primary filter element must be replaced at the same time as the secondary filter element. Refer to the Operation and Maintenance Manual , “Fuel System Primary Filter (Water Separator) Element - Replace”. Some fuel tanks use supply pipes that allow water and sediment to settle below the end of the fuel supply pipe. Some fuel tanks use supply lines that take fuel directly from the bottom of the tank.

If the engine is equipped with this system, regular maintenance of the fuel system filter is important. 6. Prime the fuel system. Refer to the Operation and Maintenance Manual, “Fuel System - Prime” for more information. Fuel Storage Tanks Drain the water and the sediment from the fuel storage tank at the following intervals: i02348492 Fuel Tank Water and Sediment - Drain Weekly SMCS Code: 1273-543-M&S Service intervals Refill of the tank NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product.

Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. This will help prevent water or sediment from being pumped from the storage tank into the engine fuel tank. If a bulk storage tank has been refilled or moved recently, allow adequate time for the sediment to settle before filling the engine fuel tank. Internal baffles in the bulk storage tank will also help trap sediment. Filtering fuel that is pumped from the storage tank helps to ensure the quality of the fuel. When possible, water separators should be used. Dispose of all fluids according to local regulations and mandates.

Fuel Tank i02518232 Hoses and Clamps - Inspect/ Replace Fuel quality is critical to the performance and to the service life of the engine. Water in the fuel can cause excessive wear to the fuel system. Water can be introduced into the fuel tank when the fuel tank is being filled. Condensation occurs during the heating and cooling of fuel. The condensation occurs as the fuel passes through the fuel system and the fuel returns to the fuel tank. This causes water to accumulate in fuel tanks. Draining the fuel tank regularly and obtaining fuel from reliable sources can help to eliminate water in the fuel. Contact with high pressure fuel may cause fluid penetration and burn hazards.

High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service in- structions may cause personal injury or death. If you inspect the engine in operation, always use the proper inspection procedure in order to avoid a fluid penetration hazard. Refer to Operation and Maintenance Manual, “General hazard Information”. Drain the Water and the Sediment Fuel tanks should contain some provision for draining water and draining sediment from the bottom of the fuel tanks.