Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

108 SEBU8726-03 Maintenance Section Fuel System Secondary Filter - Replace Refer to Systems Operation, Testing, and Adjusting, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. Remove the Element 1. Turn the fuel supply valve (if equipped) to the OFF position before performing this maintenance. 2. Place a suitable container under the fuel filter in order to catch any fuel that might spill. Clean up any spilled fuel. Clean the outside body of the filter assembly. Illustration 70 g02522538 Typical example 7. Rotate the filter element counterclockwise and remove the filter element (5).

Clean the filter bowl. Install the Element Illustration 69 g02522536 Typical example 3. Make a temporary Mark (A) across the filter before the assembly is removed. Install a suitable tube onto drain (4). Open the drain valve (3). Rotate the drain valve counterclockwise. Two full turns are required. Loosen vent screw (1). Note: Two complete rotations of the valve will release the valve from the filter element. 4. Allow the fuel to drain into the container. Remove the tube and install the valve into the filter element. Engage the threads of the valve into the filter element. Do not secure the valve. Illustration 71 g02522540 Typical example 5. Tighten the vent screw (1) securely. 1.

Locate the thread in the filter element (7) onto the threads (8). Spin on the element. Do not tighten. 6. Remove the filter bowl (2). Rotate the filter assembly counterclockwise in order to remove the assembly. Use a suitable tool in order to remove the filter bowl.