SEBU8726-03 107 Maintenance Section Fuel System Primary Filter/Water Separator - Drain 5. The secondary filter element must be replaced at the same time as the primary filter element. Refer to the Operation and Maintenance Manual , “Fuel System Filter - Replace”. i05326334 Fuel System Primary Filter/ Water Separator - Drain Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. NOTICE Ensure that the engine is stopped before any servic- ing or repair is performed. Illustration 68 g03374226 Typical example 3.
Install a suitable tube onto drain (3). Open the drain valve (2). Rotate the drain valve counterclockwise. Two full turns are required. Loosen vent screw (1). NOTICE The water separator can be under suction during nor- mal engine operation. Ensure that the drain valve is tightened securely to help prevent air from entering the fuel system. Note: Two complete rotations of the valve will release the valve from the filter element. 1. Place a suitable container under the water separator in order to catch any fluid that might spill. Clean up any spilled fluid. 4. Allow the fluid to drain into the container. 5.
Engage the threads of the valve into the filter element and tighten the drain valve by hand pressure only. Tighten vent screw securely. 2. Ensure that the outer body of the filter assembly is clean and free from dirt. 6. Remove the tube and remove the container. i04367528 Fuel System Secondary Filter - Replace Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. NOTICE Ensure that the engine is stopped before any servic- ing or repair is performed.