68 SEBU8726-03 Maintenance Section Fluid Recommendations Terminology Maintenance intervals for engines that use biodiesel – The oil change interval can be adversely affected by the use of biodiesel. Use oil analysis in order to monitor the condition of the engine oil. Use oil analysis also in order to determine the oil change interval that is optimum. Certain abbreviations follow the nomenclature of “SAE J754”. Some classifications follow “SAE J183” abbreviations, and some classifications follow the “EMA Recommended Guideline on Diesel Engine Oil”. In addition to Perkins definitions, there are other definitions that will be of assistance in purchasing lubricants.
Recommended oil viscosities can be found in this publication, “Fluid Recommendations/ Engine Oil” topic (Maintenance Section). Note: These engine oils are not approved by Perkins and these engine oils must not be used: CC, CD, CD-2, CF-4, CG-4, CH-4 and CI-4. Engine Oil Lubricant Viscosity Recommendations for Direct Injection (DI) Diesel Engines Commercial Oils NOTICE Perkins require the use of the following specifica- tion of engine oil. Failure to use the appropriate specification of engine oil will reduce the life of your engine. Failure to use the appropriate speci- fication of engine oil will also reduce the life of your aftertreatment system.
The correct SAE viscosity grade of oil is determined by the minimum ambient temperature during cold engine start-up, and the maximum ambient temperature during engine operation. Refer to illustration 42 (minimum temperature) in order to determine the required oil viscosity for starting a cold engine. Refer to illustration 42 (maximum temperature) in order to select the oil viscosity for engine operation at the highest ambient temperature that is anticipated. Table 7 Classifications for the 854 Industrial Engine Oil Specification Generally, use the highest oil viscosity that is available to meet the requirement for the temperature at start-up.
API CJ-4 ACEA E9 ECF-3 API CJ-4 and ACEA E9 oil categories have the following chemical limits: 0.1 percent maximum sulfated ash 0.12 percent maximum phosphorous 0. 4 percent maximum sulfur The chemical limits were developed in order to maintain the expected life of the engine aftertreatment system. The performance of the engine aftertreatment system can be adversely affected if oil that is not specified in table 7 is used. The life of your Aftertreatment system is defined by the accumulation of ash on the surface of the filter. Ash is the inert part of the particulate matter. The system is designed in order to collect this particulate matter.
There is a small percentage of particulate matter that is left behind as the soot is burnt. This matter will eventually block the filter, causing loss of performance and increased fuel consumption. Most of the ash comes from the engine oil which is gradually consumed during normal operation. This ash is passes through the exhaust. To meet the designed life of the product, the use of the appropriate engine oil is essential. The oil specification that is listed in table 7 has low ash content.