Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

70 SEBU8726-03 Maintenance Section Fluid Recommendations NOTICE Frequently check the specific gravity of the coolant for proper freeze protection or for anti-boil protection. For a water analysis, consult one of the following sources: Local water utility company Clean the cooling system for the following reasons: Agricultural agent Contamination of the cooling system Independent laboratory Overheating of the engine Additives Foaming of the coolant Additives help to protect the metal surfaces of the cooling system. A lack of coolant additives or insufficient amounts of additives enable the following conditions to occur:

NOTICE Never operate an engine without water temperature regulators in the cooling system. Water temperature regulators help to maintain the engine coolant at the proper operating temperature. Cooling system prob- lems can develop without water temperature regulators. Corrosion Formation of mineral deposits Rust Many engine failures are related to the cooling system. The following problems are related to cooling system failures: Overheating, leakage of the water pump and plugged radiators or heat exchangers. Scale Foaming of the coolant These failures can be avoided with correct cooling system maintenance.

Cooling system maintenance is as important as maintenance of the fuel system and the lubrication system. Quality of the coolant is as important as the quality of the fuel and the lubricating oil. Many additives are depleted during engine operation. These additives must be replaced periodically. Additives must be added at the correct concentration. Over concentration of additives can cause the inhibitors to drop out-of-solution. The deposits can enable the following problems to occur: Coolant is normally composed of three elements: Water, additives, and glycol. Formation of gel compounds Water Reduction of heat transfer Water is used in the cooling system to transfer heat.

Leakage of the water pump seal Distilled water or deionized water is recommended for use in engine cooling systems. Plugging of radiators, coolers, and small passages Glycol DO NOT use the following types of water in cooling systems: Hard water, softened water that has been conditioned with salt and sea water. Glycol in the coolant helps to provide protection against the following conditions: Boiling If distilled water or deionized water is not available, use water with the properties that are listed in Table 8 . Table 8 Freezing Cavitation of the water pump For optimum performance, Perkins recommends a 1:1 mixture of a water/glycol solution. Note:

Use a mixture that will provide protection against the lowest ambient temperature. Note: 100 percent pure glycol will freeze at a temperature of −13 °C (8.6 °F). Acceptable Water Property Maximum Limit Chloride (Cl) 40 mg/L Sulfate (SO) 4 100 mg/L Total Hardness 170 mg/L Total Solids 340 mg/L Acidity pH of 5.5 to 9.0