82 SEBU8726-03 Maintenance Section Maintenance Recommendations Maintenance Recommendations 2. Wait for 10 minutes. Do not loosen the high pressure fuel lines in order to remove air from the fuel system. i03648938 System Pressure Release Engine Oil Coolant System To relieve pressure from the lubricating system, turn off the engine. i05400894 Welding on Engines with Electronic Controls Pressurized system: Hot coolant can cause seri- ous burn. To open cap, stop engine, wait until ra- diator is cool. Then loosen cap slowly to relieve the pressure. NOTICE Because the strength of the frame may decrease, some manufacturers do not recommend welding onto a chassis frame or rail.
Consult the OEM of the equip- ment or your Perkins dealer regarding welding on a chassis frame or rail. The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repair is performed. To relieve the pressure from the coolant system, turn off the engine. Allow the cooling system pressure cap to cool. Remove the cooling system pressure cap slowly in order to relieve pressure. Proper welding procedures are necessary in order to avoid damage to the engines ECM, sensors, and associated components. When possible, remove the component from the unit and then weld the component.
If removal of the component is not possible, the following procedure must be followed when you weld on a unit equipped with an Electronic Engine. The following procedure is considered to be the safest procedure to weld on a component. This procedure should provide a minimum risk of damage to electronic components. Fuel System To relieve the pressure from the fuel system, turn off the engine. High Pressure Fuel Lines NOTICE Do not ground the welder to electrical components such as the ECM or sensors. Improper grounding can cause damage to the drive train bearings, hy- draulic components, electrical components, and oth- er components.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service in- structions may cause personal injury or death. Clamp the ground cable from the welder to the com- ponent that will be welded. Place the clamp as close as possible to the weld. This will help reduce the pos- sibility of damage. The high pressure fuel lines are the fuel lines that are between the high pressure fuel pump and the high pressure fuel manifold and the fuel lines that are between the fuel manifold and cylinder head. These fuel lines are different from fuel lines on other fuel systems. Note:
Perform the welding in areas that are free from explosive hazards. This is because of the following differences: 1. Stop the engine. Turn the switched power to the OFF position. The high pressure fuel lines are constantly charged with high pressure. 2. Ensure that the fuel supply to the engine is turned off. The internal pressures of the high pressure fuel lines are higher than other types of fuel system. 3. Disconnect the negative battery cable from the battery. If a battery disconnect switch is provided, open the switch. Before any service or repair is performed on the engine fuel lines, perform the following tasks: 1. Stop the engine.