SEBU8726-03 83 Maintenance Section Welding on Engines with Electronic Controls 4. Disconnect all electronic components from the wiring harnesses. Include the following components: Electronic components for the driven equipment ECM Sensors Electronically controlled valves Relays Aftertreatment ID module NOTICE Do not use electrical components (ECM or ECM sen- sors) or electronic component grounding points for grounding the welder. Illustration 44 g01075639 Use the example above. The current flow from the welder to the ground clamp of the welder will not damage any associated components.
(1) Engine (2) Welding electrode (3) Keyswitch in the OFF position (4) Battery disconnect switch in the open position (5) Disconnected battery cables (6) Battery (7) Electrical/Electronic component (8) Minimum distance between the component that is being welded and any electrical/electronic component (9) The component that is being welded (10) Current path of the welder (11) Ground clamp for the welder 5. Connect the welding ground cable directly to the part that will be welded. Place the ground cable as close as possible to the weld in order to reduce the possibility of welding current damage to the following components.
Bearings, hydraulic components, electrical components, and ground straps. Note: If electrical/electronic components are used as a ground for the welder, or electrical/electronic components are located between the welder ground and the weld, current flow from the welder could severely damage the component. 6. Protect the wiring harness from welding debris and spatter.