88 SEBU8726-03 Maintenance Section Battery - Replace 5. Install the new belt, use belt configuration (A). Visually check that the belt is correctly aligned. 6. Turn the screw (2) clockwise in order to tension the belt. Ensure that the link adjuster (7) is at the maximum extension, refer to illustration 46 . 7. Tighten bolt (5), nut, and bolt (6) and tighten nut and bolt (1). Tighten these nuts and bolts to 50 N·m (37 lb ft). 8. Rotate bolt (2) counter clockwise two complete revolutions and tighten nut (3) to 30 N·m (22 lb ft). 9. Install the guard, refer to OEM for more information. i03559623 Battery - Replace Illustration 45 g02729648 2. Loosen bolt (5) and loosen nut and bolt 6.
Also, loosen nut and bolt (1). Batteries give off combustible gases which can explode. A spark can cause the combustible gases to ignite. This can result in severe personal injury or death. 3. Loosen nut (3) and turn screw (2) counter clockwise. Turn the screw (2) in order to give clearance to remove the belt (4). Ensure proper ventilation for batteries that are in an enclosure. Follow the proper procedures in or- der to help prevent electrical arcs and/or sparks near batteries. Do not smoke when batteries are serviced. 4. Remove belt (4) and visually check all pulleys that the belt operates. Ensure that all pulleys are clean and free from damage. Ensure that the pulleys rotate freely.
Replace any component that is damaged. The battery cables or the batteries should not be removed with the battery cover in place. The bat- tery cover should be removed before any servic- ing is attempted. Removing the battery cables or the batteries with the cover in place may cause a battery explosion resulting in personal injury. 1. Switch the engine to the OFF position. Remove all electrical loads. 2. Turn off any battery chargers. Disconnect any battery chargers. 3. Ensure that the battery disconnect switch is in the OFF position. 4. Disconnect the NEGATIVE - cable from the NEGATIVE - battery terminal. 5. Disconnect the POSITIVE + cable from the POSITIVE + battery terminal.
Illustration 46 g02603591 (A) Belt configuration