SEBU8726-03 97 Maintenance Section Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace Ease of maintenance i02335405 Engine Air Cleaner Service Indicator - Inspect Note: Caution must be used to prevent electrical components from being damaged by excessive water when the engine is cleaned. Pressure washers and steam cleaners should not be directed at any electrical connectors or the junction of cables into the rear of the connectors. Avoid electrical components such as the alternator, the starter, and the ECM. Protect the fuel injection pump from fluids to wash the engine. Some engines may be equipped with a different service indicator.
Some engines are equipped with a differential gauge for inlet air pressure. The differential gauge for inlet air pressure displays the difference in the pressure that is measured before the air cleaner element and the pressure that is measured after the air cleaner element. As the air cleaner element becomes dirty, the pressure differential rises. If your engine is equipped with a different type of service indicator, follow the OEM recommendations in order to service the air cleaner service indicator. Ensure that care is taken that the safety labels, emission label, and any information labels are not removed during engine cleaning.
Ensure that care is taken that the safety labels, emission label, and all other information labels are not removed during engine cleaning. Aftertreatment The service indicator may be mounted on the air cleaner element or in a remote location. During the engine cleaning process, ensure that water or cleaning fluids cannot enter the aftertreatment system. If cleaning fluids enters the aftertreatment system, damage could occur. i04150591 Engine Air Cleaner Element (Single Element) - Inspect/ Clean/Replace Refer to Operation and Maintenance Manual, “Engine Air Cleaner Service Indicator-Inspect”. NOTICE Never run the engine without an air cleaner element installed.
Never run the engine with a damaged air cleaner element. Do not use air cleaner elements with damaged pleats, gaskets or seals. Dirt entering the engine causes premature wear and damage to engine components. Air cleaner elements help to pre- vent airborne debris from entering the air inlet. Illustration 55 g00103777 Typical service indicator Observe the service indicator. The air cleaner element should be cleaned or the air cleaner element should be replaced when one of the following conditions occur: The yellow diaphragm enters the red zone. NOTICE Never service the air cleaner element with the engine running since this will allow dirt to enter the engine.
The red piston locks in the visible position. Test the Service Indicator Service indicators are important instruments. A wide variety of air cleaners may be installed for use with this engine. Consult the OEM information for the correct procedure to replace the air cleaner. Check for ease of resetting. The service indicator should reset in less than three pushes. Check the movement of the yellow core when the engine is accelerated to the engine rated speed. The yellow core should latch at the greatest vacuum that is attained.