Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

96 SEBU8726-03 Maintenance Section Diesel Particulate Filter - Clean 4. Clean the cooling system filler cap and inspect the gasket. If the gasket is damaged, discard the old filler cap and install a new filler cap. If the gasket is not damaged, use a suitable pressurizing pump in order to pressure test the filler cap. The correct pressure is stamped on the face of the filler cap. If the filler cap does not retain the correct pressure, install a new filler cap. Note: Only the wall flow type of aftertreatment requires a service period, in order to remove the ash. The wall flow aftertreatment uses active regeneration in order to remove soot.

For information on removal of the (1) diesel particulate filter, refer to Disassembly and Assembly, “DPF - Remove”. Also, refer to System Operation Testing and Adjusting, “Diesel Particulate Filter - Clean”. i04650530 Diesel Particulate Filter - Clean i02151646 Driven Equipment - Check Refer to the OEM specifications for more information on the following maintenance recommendations for the driven equipment: Wear goggles, gloves, protective clothing, and a National Institute for Occupational Safety and Health (NIOSH) approved P95 or N95 half-face respirator when handling a used Diesel Particu- late Filter or Catalytic Converter Muffler. Failure to do so could result in personal injury.

Inspection Adjustment Lubrication Other maintenance recommendations Perform any maintenance for the driven equipment which is recommended by the OEM. The muffler, catalytic converter/muffler, and die- sel particulate filter will become extremely hot during engine operation. A hot muffler, catalytic converter/muffler and diesel particulate filter can cause serious burns. Allow adequate cooling time before working on or near the muffler, cata- lytic converter/muffler and diesel particulate filter. i06709044 Engine - Clean Personal injury or death can result from high voltage. Moisture can create paths of electrical conductivity. Make sure that the electrical system is OFF.

Lock out the starting controls and tag the controls DO NOT OPERATE . NOTICE Accumulated grease and oil on an engine is a fire hazard. Keep the engine clean. Remove debris and fluid spills whenever a significant quantity accumu- lates on the engine. Periodic cleaning of the engine is recommended. Steam cleaning the engine will remove accumulated oil and grease. A clean engine provides the following benefits: Illustration 54 g02524596 Typical example Easy detection of fluid leaks Maximum heat transfer characteristics