Perkins — Perkins 854E-E34TA and 854F-E34T Industrial Engines Operation and Maintenance Manual

SEBU8726-03 95 Maintenance Section Cooling System Supplemental Coolant Additive (SCA) - Test/Add Use a Coolant Conditioner Test Kit in order to check the concentration of the SCA. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Add the SCA, If Necessary NOTICE Do not exceed the recommended amount of supple- mental coolant additive concentration.

Excessive supplemental coolant additive concentration can form deposits on the higher temperature surfaces of the cooling system, reducing the engine's heat transfer characteristics. Reduced heat transfer could cause cracking of the cylinder head and other high tempera- ture components. Excessive supplemental coolant additive concentration could also result in radiator tube blockage, overheating, and/or accelerated water pump seal wear. Never use both liquid supplemental coolant additive and the spin-on element (if equipped) at the same time. The use of those addi- tives together could result in supplemental coolant additive concentration exceeding the recommended maximum. 1.

Remove the cooling system filler cap slowly in order to relieve pressure. 2. Maintain the coolant level at the maximum mark that is correct for your application. If the engine is equipped with a sight glass, maintain the coolant level to the correct level in the sight glass. 3. Clean the cooling system filler cap and inspect the gasket. If the gasket is damaged, discard the old filler cap and install a new filler cap. If the gasket is not damaged, use a suitable pressurizing pump in order to pressure test the filler cap. The correct pressure is stamped on the face of the filler cap. If the filler cap does not retain the correct pressure, install a new filler cap. 4.

Inspect the cooling system for leaks. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. i03644948 Cooling System Supplemental Coolant Additive (SCA) - Test/ Add NOTICE When any servicing or repair of the engine cooling system is performed the procedure must be per- formed with the engine on level ground. This will al- low you to accurately check the coolant level. This will also help in avoiding the risk of introducing an air lock into the coolant system.

Cooling system coolant additive contains alkali. To help prevent personal injury, avoid contact with the skin and the eyes. Do not drink cooling system coolant additive. 1. Slowly loosen the cooling system filler cap in order to relieve the pressure. Remove the cooling system filler cap. Note: Always discard drained fluids according to local regulations. Test for SCA Concentration Heavy-Duty Coolant/Antifreeze and SCA 2. If necessary, drain some coolant from the cooling system into a suitable container in order to allow space for the extra SCA. NOTICE Do not exceed the recommended six percent supple- mental coolant additive concentration. 3. Add the correct amount of SCA.

Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” for more information on SCA requirements.