Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION REMARK after engine has been stopped. 3 - 94 When checking the oil level, if the machine is inclining, make it level before carrying out CHECK DUST INDICATOR e left side of machine. 1. 2. 3. 4. 1. Open engine side cover on th Check if the yellow piston in t red zone on the outside. he dust indicator (1) overlaps the If the yellow piston overlaps t filter element immediately. For the filter element clea CLEAN AND REPLACE AIR he red zone, clean or replace the ning procedure, see "CHECK, CLEANER ELEMENT (PAGE 4-20)"". After checking, cleaning, and replacing, press the knob of dust indicator (1) to return the yell ow piston to its original position.

CHECK, DRAIN WATER SEPARAT OR The water separator serves to sep arate moisture mixed in the fuel. 1. Open up the engine side cove The water separator is in 1 located in the lower part. 2. The water level and sedime cap (2). When water and disconnect drain hose (3) fro the machine and put in a co sediment. 3. Loosen plug (5) to drain the w 4. After draining through drai immediately and pass drain h Tightening torque: 0.2 to 0. 0.3 lbft) 1. Open up the engine side cove r on the left side of the machine. The water separator is in 1 located in the lower part. piece with fuel prefilter (1) and nt are seen through transparent The water level and sedime cap (2).

When water and disconnect drain hose (3) fro sediment have accumulated, m clip (4) and take its end out of the machine and put in a co sediment. ntainer to receive the water and ater. n hose (3), tighten plug (5) ose (3) through clip (4). 3. Loosen plug (5) to drain the w 4. After draining through drai immediately and pass drain h Tightening torque: 0.2 to 0. 45 Nm (0.02 to 0.046 kgm, 0.1 to