Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING the top of the hydraulic tank. 3 - 98 When removing the o il filler cap, oil may spurt out, s o stop the engine and wait for the oil te mperature to go down, then turn the cap slowly to release the internal p ressure before removing the ca If oil has been added to above the H mark, stop the e ngine and wait for the hydraulic oil to co ol down. Then remove cover (1), loosen dra in plug (2), and drain the exc 1. Park the machine on a level ground, lower the work equipment to the ground, an d stop the engine. 2. Stop the engine, wait for approximately 5 minu tes, then check that the oil level is (G).

between the H and L marks on sight gauge NOTICE Check the oil level wh en the oil is at low temperature. If the oil is at high temperature, the oil l evel will be higher. Do not add oil if the o il level is above the H line. This may damage t he oil circuit and cause the oil to spurt out. 3. If the oil level is b elow the L line, add oil throu gh oil filler (F) at REMARK When checking the oil level, if the machine is inclini ng, make i t level before carrying out th e check.