Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION BREAKING IN THE NEW MACHINE NOTICE OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING 3 - 115 the machine under full l oad before breaking the ma chine in can adversely affect th e performance and shorten the m achine life. Be sure to break in t he machine for the initial 1 00 hours (as indicated on the se Make sure that yo u fully understand the co ntent of this manual, and pay careful attention to the followi ng points when breaking in the ma chine. Run the engine at idle for 15 seconds a fter starting it. During this ti me, do not operate the contro l levers or fuel control dial. for 5 minutes after starting it up. with heavy loads or at high speeds.

Idle the engine for 5 minutes after starti Avoid operation with heavy loads or at Immediately aft er starting the engine, av oid sudden starts, sudden a cceleration, unnecessary sud den stops, and sudden change s in direction. If there has been any Emergency stop, abno rmal actuation or trouble, turn t he starting switch key to OFF po sition. If the work equip ment is operated without su fficiently warming the machine up, response of the work equipme nt to movement of the control lev er will be slow, and the wo rk equipment may not respond as the operator desires, so alw ays perform the warming-up oper ation. Particularly in cold a reas, be sure the warming-up o peration is completed.

CHECKING OF ENGINE STARTABILITY AND NOISE When starting the engine, check that the e ngine causes no abnormal n oise and that it starts up easily and smoothly. Check also that th ere is no abnormal nois e when the engine is at idle or when the revolution rises s lightly. ngine may be When there is an abnormal noise at t he engine startup and if th at condition continues, the e ngine as soon as possible. damaged. In th at case, ask your Koma tsu distributor to check the e CHECKING OF ENGINE ACCELERATION AND DECELERATI ON When stopping the machine during the ope ration, check that there is no irregular engine revolution or that the engine does not stop sud denly.

e engine speed rises smoothly when the fuel control dial is turned to High idle (MAX). checks in a safe place, watching out for danger in the surroundings. ne performs very badly at low idle and in the acceleration and if that condition continues, the Check also that th e engine speed rises sm oothly when the fuel contro l dial is turned to High idle (M Carry out these checks in a safe place , watching out for danger in t When the engi ne performs very badly at low idle and in the acce continues, the engine may be damaged or confuse the operator's sense of driving o r lower the braking efficiency, and as a result lead to an une possible. xpected accident.

In that case, ask your Komatsu distributor to check the engine as soon as