. OPERATION OPERATION WARMING UP OPERATIONS 1. Turn fuel control dial (1) to the center position between LOW IDLE (MIN) and HIGH IDLE (MAX) and run the engine at medium speed for approximately 5 minutes with no load. 3. Check for abnormal exhaust gas color, noise, or vibration. problem is found, contact your Komatsu distributor. 3 - 116 NOTICE Do not carry out operations w hen the hydraulic oil is still at low temperature, and do not operate carry out the warming-up operat monitor shows the green di the control levers suddenly. Always ion until the hydraulic oil temperature splay. Performing the warming-up operation properly will extend th Do not suddenly accelerate the e is completed.
e service life of the machine. ngine before the warming-up operation Do not run the engine under no lo ad at low idle or high idle continuously for more than 20 minutes. Thi s will have an adverse effect on the e an adverse effect on the internal environment, and will also hav structure of the turbocharger an d engine. If it is necessary to run the engine at idle, apply a load fro speed. m time to time or run at a mid-range If the engine oil pressure monito r on machine monitor (2) lights up or the alarm buzzer sounds interm ittently, stop the engine and carry out inspection. 2. After it completing the war gauges and monitors work ming-up operation, check that all properly.
If any problem is found, carry out maintenance or r load until the engine water c (2) enters green range (A) t (A) to (B): Red range (A) to (C): Green range (C) to (D): White range epair. Run the engine under light oolant gauge on machine monitor o (C). If any