. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT ADJUST ANGLE OF BLADE EDGE WARNING ANGLE DOZER CAUTION 3 - 140 It is d angerous if t he work equipment mo ves by mistake w hen a djusting angle of the blade edge. S et the work equi stabl e condition, t hen stop the engine and lock the work e quipm ent securely with the work equipme nt lock lever. Blad e cutting ed ge angle (A) can be a djusted to me et soil conditions. STRAIGHT TILT DOZER r with screw-adjustable tilt brace. with bar handle (1) to extend a distance between Straight tilt doze r with screw-adjustab Turn the brace with bar handle (1) to etween the j oints (B), an d then blade cutting e dge angle (A) i ncreases.
To decrease the an gle, shorten the dista nce. ) is 55 deg. (B) is as shown below. Standard blade cutting edge angle (A Standard distan ce between the joints (B) is as show n belo D65EX: 1150 m m (45.31 in) m (45.15 in) D65PX: 1146 m REMARK Whe n the mach ine is installed with a fixed type tilt b race, a blade cutting ed ge angle cann ot be adjusted Standard blade cutting edge angle (A Whe n the blade cutting edge is held a t the standard angl e, the tilt amount is as shown be D65EX: 460 mm D65PX: 450 mm The a ngle of the b lade edge of the angledo zer blade can n ot be a djusted.
If the angle of the blade edge is changed b y changing the b race le ngth, an excessive b ending stress will be applied to pin, w hich may be broken. Standard blade cutting edge angle (A Standard distan ce between the joints (B) is as show n in th e table Model Standard Use D65EX 1127 mm 1117 to (44.4 in) (44.0 t