Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION POWER ANGLE POWER TILT DOZER If rod (1) is rotated to increase distance (B) between the joints is increased, cutting angle (A) is increased, too. If the former is decreased, the latter is decreased, too. The standard cutting angle (A) is 55 deg. and the standard distance (B) between the joints is 456 mm (1 ft 6 in). This is suitable for general operations. The maximum cutting angle (A) is 58 deg. and the distance (B) between the joints is 498 mm (1 ft 8 in). This is suitable for digging operations on clay soil or hard soil. In addition, this will improve the removal of the soil from the blade and reduce spillage of soil over the back of the blade.

This is suitable also for dozing operations on slopes. The minimum cutting angle (A) is 52 deg. and the distance (B) between the joints is 412 mm (1 ft 4 in). This allows the blade to gather a larger amount of soil and is suitable for hauling operations on soft soil. In addition, it makes it easier for the cutting edge of the blade to dig into the soil, so it is suitable for operations digging into hard soil. 3 - 141 SIGMA DOZER with bar handle (1) to extend a distance between Turn the brace with ba istance between the joints (B), and then blade cutting edge angle (A) increases. To decrease the angle, shorten the distance.

Standard cutting angle (A) is 46 deg Standard distanc e (B) between the j oints is 1150 mm (45.31 in). Cutting angle (A) Advantages Disadvantages Large Small