Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION OPERATION OPERATION CAUTION amount. REMARK 3. Tighten set bolt (1). 3 - 147 2. Loose n the bolt (1) of the b race, insert a suitable b ar into hole he brace, and turn i Do not adju st only either b If the length of only either brace is changed to a djust th e tilt, an e xcessive bending str ess may be applied to the center pin , which may be b roken. Be sure to le ngthen either b race an d shorten the opposit e one by the same When turn ing the brace with ba r, keep the b lade above the ground. Right tilt: Make right sid e shorter, left side Left tilt:

M ake lef t side shorter , right side l onge When the tilt is adjusted to the maximum, length ( C) o f th e brace is as shown in the follow Model Max. tilt mm (in) Brace length (C) mm (in) Shortened side Lengthened side In standar Lengthened side In standar D65EX 400 (15.8) 1,070 (42.1) 1,185 (46.7) 1,127 (