Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING 3 - 157 Since loading and unloading of th e machine is dangerous, be extremely c areful. ssion in the 1st gear. When loading or unloading the ma chine, operate it slowly with the engine speed low and the transmi Use ramps having sufficient width, length, thickness, and strength. Install them securely and set their angle to 15 deg. or less. If the ramps are deflected apprecia bly, reinforce them with blocks. Perform the loading work of the ma chine on firm, level ground. Secure sufficient distance between the shoulder of the road and the trailer. age of the machine so that the machine will not slip sideways on the ramps.

In addition, il, etc. from the ramps. Remove mud from the undercarri age of the machine so that the machin e will not slip sideways on remove water, snow, ice, grease, o Never steer the machine on the ra mps, since steering on the ramps can c ause the machine to tip o ver. If it is necessary to change the travel direction, return to the ground or to the bed of the traile r, then change the travel dir The center of gravity of the mac hine shifts suddenly at the border unbalanced and becomes dangero us. Accordingly, pass the border slowl When loading or unloading, alwa ys use ramps or a platform. Procee LOADING WORK y. the edge of a road. 1. 2. 1.

Load on firm level ground onl Maintain a safe distance from 2. Apply the trailer brakes secur ely and put blocks (1) under the tires to hold the trailer in posi tion.Set gap (3) between ramps (2) to match the distance betw een the left and right tracks, and keep angle (4) to a maximum of 15 deg. If ramps (2) bend appreciably under the weight of the machine, put wooden block (5) under t he ramps to support them. 3. Start the engine. In a cold weather, carry ou t an engine warming-up run, referring to the section, "STARTING IN COLD n this manual. EE position (F). t gear and run the engine at low d the ramps and drive slowly.

machine shifts suddenly at the and trailer, and the machine is ngerous. Accordingly, pass the ified position on the trailer. WEATHER (PAGE 3-117)", i 4. Set parking brake lever to FR 5. Set the transmission in the 1s t gear and run the engine at low idle. 6. Set the travel direction towar 7. The center of gravity of the border between the ramps unbalanced and becomes da machine shifts suddenly at the and trailer, and the machine is ngerous. Accordingly, pass the 8. border slowly. Stop the machine at the spec