Komatsu — AFTER COLD WEATHER

. OPERATION COLD WEATHER OPERATION REMARK Electrolyte Temperature Charging Rate (%) -20 ° C (-4 ° F) 100 1.31 90 1.29 80 1.27 As the battery capacity drastically drops in low temperatures, cover or remove the battery from the machine, store the battery in a warm place, and install it again the next morning. If the electrolyte level is low, add distilled water in the morning before beginning work. Do not add water after the day's work to prevent diluted electrolyte in the battery from freezing during the night. 75 1.26 AFTER COMPLETION OF WORK WARNING 3 - 164 Measure t he specific gravity a nd calculat e the charg ing rate fr om the fo llowi ng conversion table.

20°C (68°F) 0°C (32°F) -10°C (14°F) 1.28 1.29 1.30 1.26 1.27 1.28 1.24 1.25 1.26 1.23 1.24 1.25 Performing idle-runnin g of the tra cks is danger ous, stay w ell away fro m the To preven t mud, wat er, or the undercarria ge from fre ezing and making i t impossible for the machine t o move on t he following morning, o bserve th e following p recautions . body. In particular, wipe the hydraulic cylinder rods clean to Remov e all the m ud and w ater from th e machine body. In particula r, wip hydrauli rod s clean to prevent damage t o the sea l caused by mud, dirt, or drops o f water o n the rod fr om gettin g inside the s eal. Park th e machine on hard, dry ground.

If this is impossibl e, park th e machine on boards. The boa rds preve nt the trac ks from free zing to the ground, a nd allow the m achin e to be m oved the next morning. Open th e drain va lve and d rain any wa ter collecte d in the fu el syste m to p reven t it from freezing. Fill the f uel tank to capacity . This minim izes moist ure condensation i n the tank when the temperature drops. After op eration in water or mud, remov e water fro m undercarriage a s described below t o extend undercarriage service life. AFTER COLD WEATHE R d the weather becomes warmer, do as follows. all parts with oil of the viscosity specified.

When the season ch anges an d the weath er become s warmer , do as fo llows Replac e the fuel a nd oil for all parts wit h oil of the viscosity specified For det ails, see "R ECOMMENDED FU EL, COOL ANT, AND LUBRICANT (PAGE 4-12)