. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 165 BEFORE STORAGE re than 1 month), store as follows. When keeping in long-term storage (mo Clean and wash all parts, then store t he machine indoors. If the machine has to be store d outdoors, s elect l evel ground and cover the machine with a sheet. vents moisture from collecting. torage. urface of the hydraulic piston rods and the idler adjusting rods. Completely fill the fuel tank.
This pre Lubricate and change the oil before s Apply a thin coat of grease to metal s urface of the hydraulic piston rods and the idler adjustin Disconnect the negative terminals of t he battery and cover it or remove it from the machine and s tore it s eparately. Place all control levers in the neutral position, set the work equipment lock lever and parking brake l ever in the LOCK position, and set the fuel contr ol dial to the low idle position. e a density of at least 30% for the engine coolant.
To prevent rust, fill with coolant to giv If it is necessary to perform the rust-preventi on operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of oil will coat moving parts. At the same time, also charge the battery. wipe off all the grease from the hydraulic cylinder rods.
When operating the work equipment, wipe off all the grease from the hydraulic cylinder r If the machine is equipped with an air conditioner, operate the air conditioner for 3 to 5 minute s once a mon th to lubricateall parts of the air conditioner check the refrigerant level twice a ye compressor. Always run the engine at low idle when doin g this. I n addition, ar. NOTICE If the machine has been stored without carr ying out the monthly rust-prevention operation, consult your K omatsu distributor before using it. When using the machine after long-term storage, do as follows before using it. c cylinder rods. oints.
Wipe off the grease from the hydrauli Add oil and grease at all lubrication p When the machine is stored for a long period, moisture in the air will mix with the oil. Check the o il befor e and after starting the engine. If there is water i n the oil, change all the oil. STARTING MACHINE AFTER LO NG-TERM STORAGE When starting the engine after the machi ne has been in storage for a long period, carry out the warming-up operation thoroughly. For details, see the proced ure in "WARMING UP OPERATIONS (PAGE 3-116)".