. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE dust indicator (1) and return the yellow REPLACING ELEMENT 4 - 22 11. piston to i ts original 12. Close the left engin e side cover . 13. If the yello w piston i n dust indica tor (1) overlaps the red zone on the outer diameter im mediately after the outer element is cleaned, replace bot h the inner and out er elements. 1. Open the left engine side cover. 2. Remove 3 clips (2), then remov e cover (3) 3. vertically and horizontally and ro tating it to the right and left. Do not re move inne r element (5 ) at this time. cleaner body, cov 4.
Clean the interior of the air evacuator valve (6) with a clean cloth, a whisk or o NOTICE lement and cover are installed while the inner element is not installed properly, the outer element may break. ation is correct, protrusion "a" of the inner element from the air cleaner body is 35 mm (1.4 in). and reuse the inner element. When replacing the outer element, replace the inner element with new one, too. If the outer e lement and cover are ins talled while the inner element is no t installed properly, the o When install ation is correct, protrusi on "a" of the inner ele ment from the air cleaner body is 35 m Do not clean and reuse the inner elem ent.
When replacing the outer element, replace the inner ele Avoid using a non-genuine element, since the accuracy of its seal is low and dirt will enter and ca n cause an engine trouble. 5. Remove i nner element (5), then quickly install the new inner Push the i nner element in prope rly and check that it is fitted 6. Set the ne w outer e lement (4) in