. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the inner element is not CAUTION 10. Set the cleaned outer element in position, then secure cover (3) with mounting clips (2). 4 - 21 NOTICE Do not leave or keep the filter ele ment in a place where it will be exposed to the direct sunlight before and after cleaning it. Never remove inner element (5) . If it is removed, dirt will enter and can cause an engine trouble. ther tool. Do not use a screwdriver or ano 3. Hold the outer element (4), move it carefully up and down and to the left and right, and rot while pulling it out. 4.
After removing the outer ate the element to the left and right inside the air cleaner body dirt or dust from entering. with a clean cloth or tape to prevent 5. Clean the interior of the air cleaner body, cover (3) and evacuator valve (6) with a cle an cloth, a whisk or ot hers. 6. Direct dry compressed air ( less than 0.2 MPa {2.1 kg/cm2, 30.0 from inside along its pleats, then f small holes or thinner parts are f ound on the element when it is checked with an electric bulb after cleaning and drying, replace the element. hit it or beat it against something. ts or gasket or seal are damaged. When cleaning the element, do not Do not use an element whose plea 7.
Remove the clothe or taps used as a cover in Step 3. 8. Check that there is no dirt or oil stuck to the seal portion of the new e lement or clean ed element. Wipe of f any dirt or oil. NOTICE The inner element must not be c leaned and used again. When replacing the outer element, replace the i nner element at the same time. If the inner element is not instal led properly and the outer element and cover are installed, there is d damaged. anger that the outer element will be The seal portion on imitation pa rts lacks precision, and allows the entry of dust, which leads to damage of the engine. Do not use such imitation parts. 9.
Before installing the outer element, check that the inner element is f itted securely. fitted securely, push it in pr operly. When installing the cover (3), check O-ring (7) and replace it if there are any scratches or damage.