Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE END BITS AND CUTTING EDGES WARNING The symbols in the work equipment column have the following meaning. A: Straight tilt dozer (D65EX) B: Straight tilt dozer (D65PX) C: Angle dozer (D65EX) D: Sigma dozer (D65EX) E: Sigma dozer (D65WX) F: Power angle power tilt dozer (D65EX) G: Power angle power tilt dozer (D65WX, D65PX) REMARK If the cutting edge and the end bit on both sides are worn out, replace with new ones. 4 - 30 It is d angerous if t he wor k equipmen t moves during t he tu rning or replacement o peration.

Set t he w ork equipment i n a stable c ondition, set the work equipment lock lever to the LOC K position, the n stop the eng Revers e or replace the end b its and cutting edges b efor e it is worn out t o the blad e end 1. Rai se the blade to a proper height, p osition a bl ock u nder the frame to preven t the blade fr 2. Set the work equipment l ock lever to the LOCK position and stop th e engine. 3. Measure the wear of the end bit and cutting edge in accordance wit h the wea r standards g Wear st andards Item Judgement criteria (mm) No. Dimension to be measured Work equipment Standard dimension Allowable max.

value 1 Height of end bit (outside) A,C 242 187 B,F,G 204 187 D,E 228 145 2 Width of end bit A,B,C,F,G 325 300 D,E 529 440 3 Height of end bit (inside) A,B,C,F,G 204 187 D,E 201 145 4 Height of cutting edge (Center of bolt mounting hole to edge) A,B,C,D, E,F,G 102 85