. MAINTENANCE SERVICE PROCEDURE 4 - 31 4. Remove the cutting edge and the end bit and cl ean the mounting s urface. 5. Reverse or replace t he cutting edg e and the end bit whe n worn out 1) Remov e nut (1) and bolt (2), t the end bit. cutting edge and 2) Install t he cutting edge on the temporarily. Pr eliminate the pla eliminat specifie d torque. e groun d to Nut tightening t Straight tilt doz er: 392 to 530 Nm (40 t 9 to 391 lbft. Angle d ozer: 39 2 to 530 Nm (40 to 54 kgm , 289 to kgm , 289 to 391 lbft.) Sigma dozer: 3 92 to 530 Nm (40 to 54 391 lbft. Power angle po wer tilt d ozer:
392 to 5 30 Nm (40 to 289 to 39 If bolt ( 2) and n ut (1) are damaged, rep lace them wit h new o nes at the same t ime. 6. Afte r severa l hours o f running, reto urque the nut