. MAINTENANCE SERVICE PROCEDURE CHECK, ADJUST AIR CONDITIONER (Machine equipped with cab) cooling pulley (1) and N (10 kg)) amount (A) is days after the CHECK LEVEL OF REFRIGERANT WARNING flow of the sight is low, so low, it will 4 - 37 CHECKING TENSION OF COMPRESSOR BELT If t he driving belt sla ckens, it is likely to slip, lowerin efficiency. Depress t he mid point between drive p ) with a thumb (approximately compressor pulley (2 every now and then to make sure that deflection a to 18 mm (0.59 to 0.71 in).
approximately 15 mm When it is a new belt, elongation is expected in the in use, ake an adjustment in a few d Be sure to handle th e refrigerant (gas) according to the l ocal regulations . If the refrigerant use d in the air conditioner gets into you r eyes or on your hands, it may cause l oss of sight or frostbite. D o not touch the refrigerant . Never loosen any part of the refrig erant circuit. igerant gas is leaking. Do not bring any fla me close to any point where the refr If t he level of the refr igerant (gas) is low, the cooling reduced.
Run the en refrigerant gas (R134 gine at high idle, and check th a) in the refrigerant circuit thro glass (2) (inspection running at high spee (A) Correct: No bu window) of the receiver (1) when d. bbles are included in the flow are included in the flow pass continuously) s, transparent (B) Low: Bubbles (bubbles (C) None: Colorles REMARK When there are b ubbles, the refrigerant gas lev contact your refrig erant dealer to have refrigerant air conditioner is run with the refrigerant gas lev the compressor. is used as the refrigerant.
cause damage to New Freon R134a OPERATING AIR CONDITIONER OFF-SEASON Even during the off-s eason, operate the air condition er for 3 to 5 minutes once a month to maintain the oil film at al parts of the compres sor.