. MAINTENANCE SERVICE PROCEDURE ADJUSTING SHIMS AT LIFT CYLINDER HEAD 4 - 48 Correct value for play a t ball joint: 0.2 to 0.7 Standard shim thicknes Use the following procedu re to adjust the play at the ball joint to the correct v alue 1. Remove bolts (1), the n remove cap (2). nd dirt from the sliding surface of ball (3). ten bolts (1) temporarily. torque: 19 .6 to 29.4 Nm (2 to 3 kgm, 14.5 to 21.7 lbft) portion A (top) and portion B (bottom) of ball joint, and calculate average clearance C ickness is (C + 0.2) to (C + 0.7) mm. n be set in units of 0.5 mm. n remove cap (2). shim measured in Step 5, then tighten cap (2) fully with bolts (1).
to 289 Nm (23.5 to 29.5 kgm, 170.0 to 213.4 lbft) 2. Wipe off the grease a nd dirt from the slidin g surface of ball (3). 3. Remove all shims (4). 4. Install cap (2) and tigh Temporary tightening torque: 19 .6 to 29.4 Nm ( 2 to 3 kgm, 14. 5 to 21.7 l 5. Measure clearance at portion A (top) and p ortion B (b ottom) of ball joint, and calculate average clearance [C = (A+B)/2]. Set so that the shim th ickness is (C + 0.2) t o (C + 0.7 The shim thickness ca n be set in units of 0 .5 m 6. Remove bolts (1), the 7. Install the thickness of shim measured in S tep 5 , the n tighten c ap (2) full y wit h bolts (1 Tightening torque: 230 to 289 Nm (23.5 to 29.5 kgm, 170.0 to 2 13.4 lbft) 8.
Before filling with grea se, operate the work equipmen t and che ck that there is no abnormal noise o r abnormal play. gh the grease fitting of the ball joint. ff any old grease that was pushed out. 9. Pump in grease throu gh the grease fitting o f the ball j 10. After greasing, wipe o ff any old grease that was pushed