. MAINTENANCE SERVICE PROCEDURE ADJUSTING SHIMS AT CENTER BRACE 4 - 49 Correct value for play a t ball joint: 0.2 to 0.7 mm Standard shim thicknes Use the following procedu re to adjust the play at th e ball joint to t 1. Remove bolts (1), the n remove cap (2). nd dirt from the sliding surface of ball (3). ten bolts (1) temporarily. torque: 19 .6 to 29.4 Nm (2 to 3 kgm, 14.5 to 21.7 lbft) portion A (top) and portion B (bottom) of ball joint, and calculate average clearance C ickness is (C + 0.2) to (C + 0.7) mm. n be set in units of 0.5 mm. n remove cap (2). shim measured in Step 5, then tighten cap (2) fully with bolts (1). to 565 Nm (46.5 to 58 kgm, 336.3 to 419.5 lbft) 2.
Wipe off the grease a nd dirt from the sliding sur face of ball (3) 3. Remove all shims (4). 4. Install cap (2) and tigh Temporary tightening torque: 19 .6 to 29.4 Nm (2 to 3 kgm, 1 5. Measure clearance at portion A (top) and portio n B (bottom) o f ball joint, and cal culate average clearance [C = (A+B)/2]. Set so that the shim th ickness is (C + 0.2) to (C The shim thickness ca n be set in units of 0.5 m 6. Remove bolts (1), the 7. Install the thickness of shim measured in Step 5, then tighten cap (2) fully with b Tightening torque: 455 to 565 Nm (46.5 to 58 k gm, 336.3 to 4 19.5 lbft 8.
Before filling with grea se, operate the work equ ipment and ch eck that there is no abnormal nois e or abnormal play. gh the grease fitting of the ball joint. ff any old grease that was pushed out. 9. Pump in grease throu gh the grease fitting of the 10. After greasing, wipe o ff any old grease that was