Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL PREFILTER CARTRIDGE WARNING Prepare a filter wrench and a container to catch the fuel. 1. Open the inspection cover at the bottom of the fuel tank. 2. Turn fuel tank valve (1) to CLOSE position (C). 3. Open up the engine side cover on the left side of the machine. 4. Put a container under filter cartridge (4) to receive drained oil. 5. Remove connector (2) of the water separator monitor. After removing the connector, cover it with a vinyl bag to prevent water from getting on it. 6. Turn transparent cap (3) to the left with a filter wrench. (This cap is to be used again, so replace it with a new one if there is any damage on it.) 7.

Using a filter wrench, turn cartridge (4) to the left to remove it. 8. Fix earlier removed transparent cap (3) to the base of the new filter cartridge. At this time, be sure to replace O-ring (5) with a new one. Tightening torque of transparent cap: 11 Nm (1.0 kgm) When the O-ring has been replaced, coat the surface with clean fuel before installing it. 4 - 68 After the engine has been operated , all parts are at high temperature, so do not replace the filter immedi ately. Wait for all parts to cool down before starting the op eration. he engine fuel piping system when the engine is running.

High pressure is generated inside t When replacing the filter, wait for at least 30 seconds after stopping the engine to let the internal pre ssure go down before replacing the filter. . Do not bring any fire or flame close NOTICE Genuine Komatsu fuel filter cartrid ges use a special filter that has highly efficient filtering ability. W hen replacing the filter cartridge, always use a genuine Ko matsu part. The common rail fuel injection sys tem used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Ko matsu filter cartridge is used, dust or dirt may get in and cause prob lems with the injection system.

Always avoid using subst itute parts. When carrying out inspection or m aintenance of the fuel system, pay more attention than normal to th e entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely.