. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE REPLACE POWER TRAIN OIL FILTER ELEMENT WARNING 4 - 67 11. until the oil level is between (G). Run the engine at idle for a and check that the oil level is between the H and L marks on the dipstick. For details, see "C PAN, ADD OIL (PAGE 3-93 The parts and oil are at high temper ature after the engine is stopped, and may cause serious burns. W ait for the temperatu re to go d own before starting the operati on. P repare a filter wrench 1. Open inspection door (1) of the battery cover at the left rea r of the machine. 2. Set the container under the oil. filter cartridge to catch the drained 3.
Using a filter wrench, turn filt er cartridge (2) to the left to remove it. 4. Remove the grommet unde r the fender, loosen drain plug ( P), and drain the oil from inside the filter case. 5. Clean the filter holder, coat the seal surface and thread of the new filter cartridge with clea n oil, then install it. 6. When the seal surface come s into contact with the filter holder, tighten a further 2/5 turns w Tightening torque: 54 to 47.2 lbft) tighten a further 2/5 turns w ith the filter wrench. 64 Nm (5.51 to 6.53 kgm, 39.9 to