. MAINTENANCE SERVICE PROCEDURE CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS distributor to check the tightening of the clamps between the air cleaner - turbocharger - lbft) 4 - 79 CLEAN BREATHER of step (2) to remove step (2). to remove cover (4). 1. 2. 3. 1. Remove bolts (1) of step (2) to remove s tep (2 2. Remove bolts (3) to remove cover ( 4). Remove breather (5), then u se clean diesel fuel or flushing fluid Ask your K omatsu d aftercooler - engine. CHECK FOR LOOSE ROPS MOUNT BOLTS Check that t he bolts a re not loo se and t hat th ere i s no damage.
If any bolt is loose, tig hten it to t he following torqu If there is an y damag e, replace the bolt with a genuine Komatsu part. (Machine eq uipped w Bolt (1 ) (4 e ach on rig ht and left Tightening torque: 24 5 to 309 N m (25 t o 31.5 kgm , 180.8 to 227.8 INSPECTION OF AFTER-COOLER CIRCUIT FOR LOOSENED BOLTS AND NUT Check each clamp for loosenin g. If any clam p is f ound loosened, tighten it further.