. MAINTENANCE SERVICE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT NOTICE from the ripper circuit, lever to the right to each (a) (b) (c) (d) (A) (B) RAISE HOLD LOWER FLOAT RIGHT TILT LEFT TILT 4 - 85 Finish the s teps o f operating the blade control lever to the front and back, and to the r ight and left, t o each stroke end within 15 seconds af ter the engine has stopped. After th e engine stops, pressure inside the accumulator begin s to gradually go down, so the pressur e cannot b e released except right a fter the engine stops. 1. Lower the w ork equipme nt and stop t he engine. 2. Turn t he startin g switch t o ON positio 3.
Set th e wor k equipment l ock lever to the FREE position. 4. Opera te the blade control lever fully t o the front, rear, left , and right t o release the pressure from the hydraulic circuit elease opera te the contro stroke end. hydrauli an left 5. Set th e wor k equipment l ock lever to the LOCK position.