. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN DAMPER CASE WARNING 4 - 86 The parts and oil is very hot just after the op eration. Wait until the oil temperature drops , then start the work. The cove undercover is r when direct heavy (22 kg (49 lb)). Never ly beneath it. When removin try to open or close the g bolts (2), carry out the work Whe oil o Refi ll capacity: 1 1. Re move the u ndercover from the rear bottom of the machine s. bo 1 2 3 dy as follow ) Remove 2 bolts (1) from the front sid e of the machine body. ) Holding the cover, remove 2 bolts (2 ) from the rear side of the machin e body. open the cover gradually.
f machine ous place ) Lower and open the cover gradually (A) Front o (B) Danger f machine ous place 2. Re move oil lev el plug (3) and oil filler plug (4), then remove dra plu in plug (5) t o drain the oil. After the al l oil is drained, tighten g (5). h the hole of oil filler plug (4) until the oil level ttom edge of the hole of oil level plug (3). e oil, tighten plugs (3) and (4). 3. Ad d oil throug rea ches the bo ttom edge of the hole of 4. Aft er refilling th e oil, tighten plugs (3) an