Komatsu — OPERATION

. ATTACHMENTS, OPTIONS HANDLING HYDRAULIC RIPPER OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WALK-AROUND CHECK PRECAUTIONS WHEN OPERATING height. ADJUSTING POSTURE OF WORK EQUIPMENT 6 - 5 1. Check for wear of the p oint at t he tip o f the shank, ch eck the mounti ng condition, and check f or damage to the rivets. If a ny problem i s found, replace or repai Travel in lo w speed and lower t he rippe move digging dep th is reache d, move the con trol leve r to the HOLD positio Do not dig the shank in deep when star ting digging op erations During ripp ing operatio ns, neve r turn t he machine s uddenly or trav suddenly o r traveling in reverse , raise t he shank from the ground surface.

When carry ing out diggin g operations wi th only 1 shank , always use th e center s hank. Re move b oth side s hanks. When starti ng to travel u p a stee p slope or when r eachi ng the bottom of the slope , the poi nt may t ouch the g round. On hard gro und, there is danger of the p oint breaking if it touches the g round, so raise th e shank to the maximum ADJUSTMENT OF DIGGING DEPTH There are mo unting holes for the p in in th e shank. Selec t the mounting hole to m atch the digging depth. Pin hole position Use Max. digging depth W (A) di hen there is special need to g deeply 585 mm (23.0 in) (B) N ormal 475 mm (18.7 in) (C) W hen not using ripper -