Komatsu — TRAVELING ON SLOPES

OPERATION MACHINE OPERATIONS AND CONTROLS REMARK Travel down fills with the sprocket side down. If the machine travels down with the sprocket side up, the track tends to become loose, and that can cause skipping pitches. 2. When traveling up a steep hill of more than 15є, set the work equipment to the posture shown in the diagram on the right. TRAVELING DOWNHILL To brake the machine during downhill runs, put the travel lever in the neutral position. This will cause the brake to be automatically applied.

IF SHOES SLIP When traveling uphill, if the shoes slip or it is impossible to travel uphill using the force of the track only, it is possi- ble to use the pulling force of the arm to help the machine travel uphill. ENGINE STOPPED ON SLOPE If the engine stops when traveling uphill, move the all levers to the neutral position, then start the engine again. PRECAUTIONS ON SLOPES If the engine stops when the machine is on a slope, never use the left work equipment control lever to carry out swing operations. The upper structure will swing under its own weight. Do not open or close the sliding door when traveling or operating on slopes. The operating force may change suddenly.

Always set the sliding door to the LOCK position. 3-73