Komatsu — ESCAPE FROM MUD

MACHINE OPERATIONS AND CONTROLS OPERATION ESCAPE FROM MUD Always operate carefully to avoid getting affixed in mud. If the machine does get affixed in mud, do as follows to get the machine out. STUCK ONE SIDE OF TRACK NOTICE When using the boom or arm to raise the machine, always have the bottom of the bucket in contact with the ground. (Never push with the teeth). The angle between the boom and arm should be 90єt to 110є. The same applies when using the inverting bucket. When only one side is stuck in mud, use the bucket to raise the track, then lay boards or logs and drive the machine out. If nec- essary, put a board under the bucket also.

STUCK BOTH SIDES OF TRACKS When the tracks on both sides are stuck in mud and the machine will not move, lay boards as explained above, and dig the bucket into the ground in front. Then pull in the arm as in normal digging operations and put the travel levers in the FOR- WARD position to pull the machine out. 3-74