Komatsu — CLEAN INSIDE OF COOLING SYSTEM

MAINTENANCE MAINTENANCE PROCEDURE Mixing rate of water and antifreeze 5.2 1.37 5.1 1.35 WARNING Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. When removing the drain plug, be careful not to get water containing antifreeze on you. I If it gets in your eyes, flush your eyes with large quantities of fresh water and see a doctor at once. Use city water for the cooling water. If river water, well water or other such water supply must be used, contact your Komatsu distributor. We recommend use of an antifreeze density gauge to control the mixing proportions. Prepare a container to catch drained coolant: Min 10.3 liters (2.72 US gal) capacity.

Prepare a hose to supply water. 1. Stop the engine. 2. Open the engine hood, then turn radiator cap (1) slowly until it contacts the stopper, and release the pressure. 3. Keep radiator cap (1) pushed in, then turn it until it con- tacts the stopper, and remove it. 4. Set containers under drain valve (2) and drain plug (3) to catch the coolant mixture. 5. Open drain valve (2) at the bottom of the radiator and drain the coolant. Then remove drain plug (3) in the cylin- der block and drain the coolant. 6. After draining the coolant, close drain valve (2) and drain plug (3), and add fresh tap water.

When the radiator is full, start the engine, run at low idling to raise the water temperature to at least 90єC, then continue to run for approx. 10 minutes. 7. Stop the engine, open drain valve (2) and drain plug (3), and drain the water. 8. After draining the water, clean the radiator with detergent. For details of the method of cleaning, see the instructions given on the detergent container. 4-23 Min. atmospheric temperature °C –10 –15 –20 –25 °F 14 5 –4 –13 Amount of antifreeze liters 3.1 3.7 4.2 4.7 US gal 0.82 0.98 1.11 1.24 Amount of water liters 7.2 6.6 6.1 5.6 US gal 1.90 1.74 1.61 1.48