MAINTENANCE PROCEDURE MAINTENANCE 9. Close drain valve (2), then wrap drain plug (3) with seal- ing tape and close it. 10. Add tap water and antifreeze through the water filler until it reaches the mouth of the filler. Decide the ratio of the mixture of antifreeze and water according to the “water and antifreeze mixing ratio table”. 11. To remove the air in the coolant, run at low idling for 5 minutes, then run for a further 5 minutes at high idling. (Leave the water filler cap off when doing this.) 12. Drain the cooling water inside reserve tank (4), clean the inside of the reserve tank, then add water so that the coolant is midway between the FULL and LOW marks. 13.
Stop the engine and tighten the cap. Check the coolant level and add water if necessary. WASH INSIDE OF FUEL TANK 1. Open side covers (1). 2. Open drain valve (2) and drain the fuel. When doing this, be careful not to get fuel on yourself. 3. Remove cover (3) at the side of the tank. 4. Wash the inside of the tank. 5. After washing the tank, tighten drain valve (2) and install cover (3). 6. Install covers (1). 4-24