Komatsu — Inspection

MAINTENANCE MAINTENANCE PROCEDURE CHECK AND ADJUST TRACK TENSION (Machine equipped with steel shoes, road liners) WARNING The track tension is checked with the machine raised, so it is extremely dangerous if the machine comes down by mistake during the inspection. Stop the engine and set the safety lock lever to the LOCK position to prevent the machine from moving. Never put any part of your body under the track or track frame while measuring, and be extremely careful when taking the measurements.

For details of starting the engine and operating the work equipment, see "BEFORE STARTING ENGINE (PAGE 3-38)", "STARTING ENGINE (PAGE 3-51)", "AFTER STARTING ENGINE (PAGE 3-54)", and "WORK EQUIPMENT CONTROLS AND OPERATIONS (PAGE 3-65)" in the OPERATION section. The condition of wear of the undercarriage pins and bushings differs according to the working conditions and type of soil, so check the track tension regularly and be sure to maintain it at the standard value. Carry out the inspection and maintenance under the same conditions as normal operations (with mud clogging the parts normally clogged by mud). Inspection 1. Raise the chassis with the boom and arm.

When doing this, operate the levers slowly. 2. Measure the clearance between the roller surface of the link and the track roller tread at the 3rd roller from the sprocket. Standard clearance: 60 – 100 mm (2.4 – 4.0 in) If the track tension is not at the standard value, adjust it in the following manner. 4-27