Komatsu — Inspection

MAINTENANCE PROCEDURE MAINTENANCE CHECK AND ADJUST RUBBER SHOES TENSION (Machine equipped with rubber shoes) WARNING The rubber shoes tension is checked with the machine raised, so it is extremely dangerous if the machine comes down by mistake during the inspection. Stop the engine and set the safety lock lever to the LOCK position to prevent the machine from moving. Never put any part of your body under the track or track frame while measuring, and be extremely careful when taking the measurements.

For details of starting the engine and operating the work equipment, see "BEFORE STARTING ENGINE (PAGE 3-38)", "STARTING ENGINE (PAGE 3-51)", "AFTER STARTING ENGINE (PAGE 3-54)", and "WORK EQUIPMENT CONTROLS AND OPERATIONS (PAGE 3-65)" in the OPERATION section. The wear of the rubber shoe will vary with the work conditions and type of soil, so inspect the wear and track ten- sion whenever necessary. In particular, on new machines or after new tracks have been installed and the tension has been set to the speci- fied value, the track tension will become loose in the first 5 to 30 hours when the machine has been used for a cer- tain amount of repeated travel.

If the track tension is adjusted frequently until the initial loosening no longer occurs, this will prevent the shoes from coming off due to insufficient track tension. If operations are carried out when the rubber shoe is loose (rubber shoe tension: Min.40 mm (1.6 in)), the track will come off and it will cause premature wear of the core. Inspection 1. Set the connection (M mark) of the rubber shoe at the top midway between the two axles. 2. Raise the chassis with the boom and arm. When doing this, operate the levers slowly. 4-32