MAINTENANCE MAINTENANCE PROCEDURE 3. The standard tension is a clearance of 30 – 35 mm (1.18 – 1.38 in) between the roller surface of the track shoe and the track roller tread at the 3rd track roller from the sprocket. If the track tension is not at the standard value, adjust it in the following manner. Adjustment Adjustment WARNING Grease inside the adjusting mechanism is under high pressure. Grease coming from plug (1) under pressure can penetrate the body causing injury or death. For this reason, do not loosen plug (1) more than one turn. Do not loosen any part other than plug (1). If the track tension is not relieved by this procedure, please contact your Komatsu distributor.
When increasing tension Prepare a grease gun 1. Pump in grease through grease fitting (2) with a grease gun. 2. To check that the correct tension has been achieved, move the machine backwards and forwards. 3. Check the track tension again, and if the tension is not correct, adjust it again. 4. If the tension is yet loose after applying pressurized injec- tion of grease, it is necessary to replace the rubber shoes or seal inside of cylinder. Contact your Komatsu distribu- tor for repair. 4-33