Komatsu — REPLACE RUBBER SHOES

MAINTENANCE PROCEDURE MAINTENANCE When loosening tension WARNING It is extremely dangerous to replace the grease by any method except the procedure given below. If the track tension is not relieved by this procedure, replace contact your Komatsu distributor. 1. Loosen plug (1) gradually to release the grease. 2. Turn plug (1) a maximum of one turn. 3. If the grease does not come out smoothly, move the machine backward and forwards a short distance. 4. Tighten plug (1). 5. To check that the correct tension has been achieved, move the machine backwards and forwards. 6. Check the track tension again, and if the tension is not correct, adjust it again.

REPLACE RUBBER SHOES (Machine equipped with rubber shoes) WARNING Carry out this operation with two workers. The opera- tor must move the machine in accordance with the signals from the other worker. The track is replaced with the chassis raised, so it is extremely dangerous if the machine is lowered by mistake while the track is being replaced. During the replacement operation, operate only the track that is being replaced. Do not operate any other part. Grease inside the adjusting mechanism is under high pressure. Grease coming from plug (1) under pres- sure can penetrate the body causing injury or death. For this reason, do not loosen plug (1) more than one turn.

Do not loosen any part other than plug (1). If the track tension is not relieved by this procedure, please contact your Komatsu distributor. NOTICE It is possible to replace rubber shoes with steel shoes or road liners, but this makes it necessary to remove and adjust the idler cushion, so please contact your Komatsu distributor. Grease gun Prepare the following: Steel pipe 4-34