Komatsu — REPLACE RUBBER SHOES

MAINTENANCE MAINTENANCE PROCEDURE Removal of rubber shoe WARNING It is extremely dangerous to replace the grease by any method except the procedure given below. If the track tension is not relieved by this procedure, please contact your Komatsu distributor. Check that all the grease has been released before rotating the sprocket to remove the rubber shoe. 1. Raise the chassis with the boom and arm. When doing this, operate the levers slowly. 2. Loosen plug (1) gradually to release the grease. 3. Turn plug (1) a maximum of one turn. 4.

Fit the steel pipes inside the rubber shoe, rotate the sprocket in reverse, so that the steel pipes make the rub- ber shoe come up from the idler, then slide to the side to remove. 4-35