Komatsu — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. Prepare the following: Container to catch drained oil: Min. 7 liters (1.85 US gal) capacity Refill capacity of oil pan: 7 liters (1.85 US gal) Filter wrench 1. Set the container under drain valve (P) on the bottom of the machine to catch the oil. 2. Loosen drain plug (P) slowly and drain the oil. Be careful not to get oil on yourself. 3.

Check the drained oil, and if there are excessive metal particles or foreign material, please contact your Komatsu distributor. 4. Tighten drain plug (P). 5. Open the engine hood, then using the filter wrench, turn filter cartridge (2) to the left to remove it. REMARK Put a cloth in contact with the notched part of the oil container guide. This makes it possible to prevent the area around the fil- ter holder from becoming dirty. 6. Clean the filter holder, fill the new filter cartridge with clean engine oil, coat the packing surface and thread of the filter cartridge with engine oil (or coat it thinly with grease), then install the filter cartridge to the filter holder.

NOTICE Check that there is no old packing stuck to the filter holder. If there is any old packing remaining, it will cause oil leakage. 7. When installing, tighten until the packing surface contacts the filter holder, then tighten a further 1/2 turn. 4-65