MAINTENANCE PROCEDURE MAINTENANCE EVERY 5000 HOURS MAINTENANCE Maintenance for every 50, 100, 250, 500 and 1000 hours service should be carried out at the same time. CHANGE OIL IN HYDRAULIC TANK WARNING The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before changing the oil. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it care- fully. NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than dur- ing normal bucket operations. For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-18)" when carrying out maintenance.
Prepare the following. Container to catch drained oil: min. 57 liters capacity Refill, capacity: 57 liters (15.05 US gal) Prepare a handle for the socket wrench set. 1. Swing the upper structure so that the drain plug under the hydraulic tank comes at the middle of the left or right track. 2. Retract the arm and bucket cylinders to the stroke end, then lower the boom and put the bucket teeth in contact with the ground. 3. Lower the blade to the ground. (machine with blade specification) 4. Lock the safety lock lever and stop the engine. 4-74