Komatsu — CONTROL PATTERN CHANGE PROCEDURE

ATTACHMENTS AND OPTIONS CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE CHANGING MACHINE CONTROL PATTERN (IF PAT- TERN CHANGE VALVE EQUIPPED) WARNING When changing the operating pattern of the machine, set the machine in the parking posture, stop the engine, check that the safety lock lever is at the LOCK position, then change the operating pattern. To prevent personal injury caused by mistaken operation, test operate the machine and check that the display on the operating pattern card is the same as the movement of the machine. If it is not the same, replace the operating pattern card immediately with the card that matches the operating pattern.

When checking the movement of the machine, check carefully that the surrounding area is safe, and operate slowly. CONTROL PATTERN CHANGE PROCEDURE 1. Identify the operating pattern plate that shows the operat- ing patterns and the hexagonal part of the selector valve located on the floor plate pf the operations compartment. 2. Change the pattern according to the operating pattern plate stuck to the floor plate. 3. Rotate the hexagonal part so that the slot on the hexago- nal part will match the new operating pattern described on the operating pattern plate. 4. Change to an operating pattern card (insert it in the holder) that matches the selected operating pattern. 6-13