Komatsu — BEFORE STARTING ENGINE

OPERATION MACHINE OPERATIONS AND CONTROLS CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING When removing the oil filler cap, oil may spurt out, so turn the cap slowly to release the internal pressure before removing the cap. 1. If the work equipment is not in the condition shown in the diagram on the right, start the engine, run the engine at low speed, retract the arm and bucket cylinders, then lower the boom, set the bucket teeth in contact with the ground, and stop the engine. 2. Check sight gauge (G). The oil level should be between the H and L lines. NOTICE Do not add oil above the H line. This will damage the hydraulic circuit or cause the oil to spurt out.

If oil has been added to above the H level, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from drain plug (P). 3. If the oil level is below the L line, remove cover from top of the hydraulic tank and add oil through oil filler (F). 4. When oil is refilled, fully extend each cylinder of the boom, arm and bucket as illustrated at right, then screw the oil filler cap again after it was removed, and pressur- ize the hydraulic tank interior. NOTICE Be sure to pressurize the hydraulic tank. If it is not pres- surized, the pump will suck in air, and this will adversely affect the equipment. 3-43