Controls - 36 SK1050 Operator’s Manual Controls Item Description Notes 4. Worklight switch c00ic048w.eps To turn on, press top. To turn off, press bottom. 5. Ignition switch To start engine, insert key and turn clockwise. To stop engine, turn key counterclockwise. IMPORTANT: • If engine does not start or stalls, turn key to STOP and then restart. • Do not allow starter motor to run continuously for more than 20 seconds. • Unit will buzz when key is in on position without engine running. 6. Lift arm control To move lift arms down, push. To float, push forward to end. To move lift arms up, pull. To curl attachment up, move to left. To curl attachment down, move to right. IMPORTANT:
Exercise caution when lifting loads. See page 94 for operating capacities. 7. Attachment drive control To engage attachment drive in reverse, push forward. To engage attachment drive in forward, pull back. IMPORTANT: Use foot pedal to hold attachment control in the on position when hands are busy operating lift arm or track drive controls.