SK1050 Operator’s Manual Prepare - 49 Connect Attachment Hydraulic Hoses If attachment requires hydraulic power for operation, connect hydraulic hoses. Pressurized fluid or air could pierce skin and cause severe injury. Refer to operator’s manual for proper use. To help avoid injury: Escaping pressurized fluid can cause injury or pierce skin and poison. Before disconnecting a hydraulic line, turn engine off and operate all controls to relieve pressure. Lower, block, or support any raised component with a hoist. Cover connection with heavy cloth and loosen connector nut slightly to relieve residual pressure. Catch all fluid in a container.
Before using system, check that all connections are tight and all lines are undamaged. Use a piece of cardboard or wood, rather than hands, to search for leaks. Wear protective clothing, including gloves and eye protection. If you are injured, seek immediate medical attention from a doctor familiar with this type of injury. Hot parts may cause burns. Do not touch until cool. To help avoid injury: Wear gloves when connecting and disconnecting hydraulic hoses and wait until unit has cooled before touching hydraulic components. Single Circuit Auxiliary 1. Turn off engine. 2. Cycle attachment drive control to relieve residual pressure at hydraulic couplers. 1 1 3.
Remove dirt and debris from hydraulic couplers. 2 2 4. Connect male coupler on attachment to female coupler (3) on unit. 3 3 5. Connect female coupler on attachment to male coupler (1) on unit. 6. If needed, connect attachment case drain hose to case drain connector (2). t35om011w.eps 7. Ensure that connections are secure by pulling on hoses.