Prepare - 50 SK1050 Operator’s Manual Connect Attachment Dual Circuit Auxiliary 1. Turn off engine. 2. Cycle attachment drive control to relieve residual pressure at hydraulic couplers. 3. Remove dirt and debris from hydraulic couplers. 4. Pull knob (6) to relieve residual pressure in manifold. 5. Connect male coupler on attachment to female coupler (2) on unit. 6. Connect female coupler on attachment to male coupler (1) on unit. 7. If needed, connect attachment case drain hose to case drain connector (3). Primary circuit: connectors 1 & 2 Secondary circuit: connectors 4 & 5 8. For attachments that have a secondary function, connect those hoses to the secondary circuit (4, 5).
To use the secondary function, see “Attachment drive control” on page 36. 9. Ensure that connections are secure by pulling on hoses.